Casio DT-X100 Series Software Manual page 75

power is turned off, all the parameters related to Bluetooth communication return to their default
states. Therefore it is necessary to disconnect the Bluetooth connection at the higher level, and then
reconnect.
(8) Bluetooth power supply status
ⅰ Bluetooth power is turned on by the following operation.
This is the case if the BluetoothON operation was performed by a tool, and the BTLIB Initialize
function was called.
ⅱ Bluetooth power is turned off by the following operation.
This is the case if the BluetoothOFF operation was performed by a tool, and the BTLIB DeInitialize
function was called.
ⅲ Default state
- The power is off in the default state after a full reset.
ⅳ Operation on terminal reset
- WEC7: The power turns off. However, it is on if the tool selected on after the reset.
- WEH6.5: The power state which preceded the reset is restored.
ⅴ Processing during a terminal suspend and resume
- On suspend: The module power turns off.
- On resume: The power state which preceded the suspend is restored.
75