Casio DT-X100 Series Software Manual page 55

(2) Laser focus
If scanning takes place with the laser beam emitted onto multiple bar codes located near each
other, it can be difficult for the user to distinguish which barcode was correctly scanned. In that
case, when the laser focus function is enabled, the scanned barcode is indicated by the laser
when barcode scanning is successful, and a notification is sent to the user saying which barcode
was scanned. The laser scanner library can be used to set "Enable" or "Disable" for laser focus.
This can also be set using Scanner Settings on the Control Panel.
The default is "Disable laser focus".
(3) Trigger key startup
If "Turn on with the Trigger key" has been set as a power on factor, pressing a trigger key while the
power is off turns the power on. This setting allows the user turn the power off while an application
that uses the scanner is running, then press the trigger key to perform "turn on the power -> scan a
barcode", as a single action.
The default is off.
(4) Trigger key specification
Various keys such as Enter key, up/down/left/right cursor keys, side trigger keys, and center
trigger key on the front of the terminal can be set as the trigger key.
The default is that only side and center trigger keys are enabled.
(5) Operation configuration information file
The information for the various setting values can be stored in a file and saved, or the system can
be restored from that fie.
The configuration file storage location and its name are as follows.
Configuration file location: FlashDisk¥System Settings
Configuration file name: OBRDRV.ini
 Saving configuration files
All setting content set in the barcode scanner library is saved in text files.
 Configuration file restoration
The configuration file is loaded and settings stated in the file set in the barcode scanner library are
set in parameter tables in the barcode scanner library. The parameter table settings are reflected
in the driver when the barcode scanner driver is opened.
[Remarks] The barcode scanner driver loads the configuration file when a reset is executed.
If no configuration file is available, the default settings are set.
55