Casio DT-X100 Series Software Manual page 124

(2) Registration process
The procedure for registering IP information with this tool is as follows.
i Set the terminal in the LAN Cradle.
ii Start this tool (the LAN cradle setting tool).
iii The tool acquires IP information from the LAN cradle, and displays an operation screen set with
the IP information. The default value is used if reading IP information fails.
iv Click the Set button after inputting setting information from the Tool screen.
v Check the setting information and, if there is no problem, write the IP information to the LAN
cradle.
vi If a number of units is specified from the Tool screen, the IP address auto increment *1 process
is applied. If the number of units is unspecified, nothing is displayed, and the system stands by
for operation.
vii Click Close or the X button to close this tool.
*1 IP address auto increment process
If the number of units is specified, the fourth octet of the IP address is automatically incremented
by 1 after the Set button is pressed to set the IP information.
If the incremented result reaches 255, it returns to 1.
This function can be used with a single terminal to set the multiple LAN cradles sequentially.
[Caution]
If the switch at the lower left of the cradle is operated while there is a terminal unit placed in the LAN
cradle, the cradle may not operate normally. Therefore, move the switch to the LAN position before
placing the terminal unit in the LAN cradle.
124