Installing The Right Fan - Dell NOT22422 Owner's Manual

Steps
1. Disconnect the right-fan cable from the connector on the system board.
2. Remove the two (M2x4) screws that secure the right fan to the palm-rest assembly.
3. Lift the right fan from the outside and remove it from the palm-rest assembly.

Installing the right fan

Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
CAUTION: The information in this installation section is intended for authorized service technicians only.
The following image indicates the location of the right fan and provides a visual representation of the installation procedure.
58 Removing and installing Field Replaceable Units (FRUs)