Endress+Hauser Levelflex FMP53 Operating Instructions Manual page 132

Description of device parameters (operating menu)
Options
Factory setting
Decimal places 4
Navigation
Prerequisite
Description
Selection
Factory setting
Display interval
Display damping
Navigation
Description
Input range
Factory setting
132
• None
• Level linearized
• Distance
• Current output 1
• Current output 2
• Measured current
• Terminal voltage
• Electronics temperature
For level measurements and 1 current output
None
For level measurements and 2 current outputs
Current output 2
Setup ® Advanced setup ® Display ® Decimal places 4
A measured value is specified in the Value 4 display parameter (® ä 131).
Use this function to specify the number of decimal places for measured value 4. This setting does
not affect the measuring or computational accuracy of the device. The arrow displayed between
the measured value and the unit indicates that the device computes with more digits than are
shown on the local display.
• x
• x.x
• x.xx
• x.xxx
• x.xxxx
x.xx
(® ä 92)
Setup ® Advanced setup ® Display ® Display damping
Use this function to set the reaction time of the local display to fluctuations in the measured value
caused by process conditions. A time constant is entered for this purpose: if a low time constant is
entered, the display reacts very quickly to fluctuating measured variables. If a high time constant
is entered, the display reaction is damped.
0 to 999 s
0 s
Levelflex FMP53
Endress+Hauser