Table of Contents
Advertisement
Adjustment by Using Registration Marks
The plotter reads the registration marks to perform alignment of the origin point, adjustment of the vertical distance,
and correction of the distortion. Depending on the number of marks, the adjustment method may differ.
Mark Scan Mode
Adjusts the horizontal distance and the tilt. Registration marks at lower left and
lower right are read and the distance between these two marks is adjusted so as
2points
to be the same distance as you set in the [X] of [Mark Distance] ( "Registration
Marks Setting" on page 24).
Adjusts the vertical and horizontal distance and the tilt. Registration marks at
lower left + lower right and lower left + upper left are read and the distances
3points
between each pair of the marks are adjusted so as to be the same distances as
you set in the [X] and [Y] of [Mark Distance] ( "Registration Marks Setting" on
page 24).
Registration marks at lower left, lower right, upper left, and upper left are read
and are adjusted to the registration mark positions calculated from the distances
4points
you set in the [X] and [Y] of [Mark Distance] ( "Registration Marks Setting" on
page 24).
For a long image, like one whose length in the feed direction is more than 2
Area (segment area
m, corrects the distortion produced during the printing process. By using the
adjustment)
intermediate registration marks as boundaries, the image is divided in the feed
direction into several areas and 4points adjustment is performed.
<For rear loading/sheet>
Upper left
Lower left
Adjustment to be done
Upper right
Lower right
Settings in the [ ARMS Setting] Screen
1
2
In the [ARMS Setting] screen, you set detailed conditions to use the ARMS functions.
In the main screen ( page 9), click
Set whether to hold down the media with the paper-weight when the
sensor reads the registration marks.
1
Paper-Weight
Off
On
Set the tool that is used for manual axis alignment. Select from [Loupe]
Axis Alignment
2
and [Light Pointer].
Tool
Axis Alignment (page 27)
Click this key and then use the keyboard to move the tool to the position
at which the you want to cut the test pattern.
Up/down/left/right
Position
3
High-speed
(Use Keyboard)
movement
Skew
Automatically adjusts the scanning level of the sensor that scans
4
Sensor Adjust
registration marks. Click [Execute] to start the automatic adjustment.
Sensor Adjust (page 27)
2 6
7. A R MS Set t in g [A R M S]
3
4
5
6
7
[ARMS] to open the [ARMS Setting] screen.
The paper-weight will not be used.
The paper-weight will be used.
Press one of the [←↑↓→] keys on the keyboard.
Press the [Ctrl] key and one of the [←↑↓→] keys on
the keyboard at the same time.
Press the up/down arrow key and the left/right
arrow key at the same time. For example, [←] and
[↑] or [↓] and [→].
Advertisement
Table of Contents
