Click this key and then use the keyboard to move the tool to the position
at which the you want to cut the test pattern.
Up/down/left/right
Position (Use
1
High-speed
Keyboard)
movement
Skew
Runs three cutting tests by changing the cutting force by 1. The tests are
2
Test for force
performed with the value that you set and the values that are increased
or decreased by 1 from the original value.
Runs three cutting tests by changing the offset value by 1. The tests are
Test for cutter
3
performed with the value that you set and the values that are increased
offset
or decreased by 1 from the original value.
Runs one cutting test under the tool condition that you set.
4
Cut Test
Test Cutting Patterns (page 15)
How to Check Offset (page 15)
Press one of the [←↑↓→] keys on the keyboard.
Press the [Ctrl] key and one of the [←↑↓→] keys
on the keyboard at the same time.
Press the up/down arrow key and the left/right
arrow key at the same time. For example, [←] and
[↑] or [↓] and [→].
2. Set t in g Too l C o nd it io n s [C ON D ITION ]
Test Cutting Patterns
Cut Test (once with the original
Test for force/Test for cutter offset (three times with the original
value)
value and ±1)
1cm
1cm
How to Check Offset
Check if the offset value is set correctly by using the following information as a reference:
Not enough adjustment. Increase the offset value.
Optimal offset value.
Too much adjustment. Decrease the offset value.
1 5
-1
Original
+1
value