GRAPHTEC OPS675 User Manual page 12

Displays the name of the tool condition that is currently selected. To
1
save a tool condition as a new one, enter a new fi le name here.
Media Name
Media Name (page 16)
2
Tool Specify the part no. of the cutter blade, or the pen.
Set the force of the cutter or the pen.
3
Force
Setting range
Set the move speed of the tool.
4
Speed
Setting range
Set the acceleration of the tool.
5
Accel
Setting range
Fine-adjust the difference between the tip of the blade and the center of
the plunger. Set this value based on the type of the cutter blade that you
6
Offset use.
What is Offset (page 12)
Guideline of Offset Setting (for Each Cutter Blade) (page 12)
Displays detailed information on the cutter blade and the plunger of the
7
About the blades
tool that is currently selected.
Displays advanced setting items.
8
Advanced
Advanced Control of Tool Behavior (page 13)
Saves the set content as the current media name and closes the tool
9
OK condition setting screen. To newly save it, enter the optional fi le name
into media name.
10
Cancel Cancels the settings and closes the tool condition setting screen.
Guideline for Settings
Refer to the Cutter Blade Manual.
1 ~ 48
1 to 105 cm/sec.
1 ~ 8
2. Set t in g Too l C o nd it io n s [C ON D ITION ]
Guideline for Settings (When Plotter Pen is Selected)
Pen type
Water-based fi ber-tip pen KF7000 Series
Oil-based ballpoint pen KB700-BK
What is Offset
It will adjust the difference between the tip of the blade in the plunger
and the center of the plunger. There are standard adjustment values
for each cutter blades. Fine adjustment will be made to that standard
values here. (Adjustment will be made with standard value as 0.)
For the Pouncing, specify the distance (length) of 1 to 99mm, which
allows the tool to go down.
Guideline of Offset Setting
Refer to the Cutter Blade Manual.
1 2
Speed
Part no. Force
(cm/sec.)
10 ~ 12 30
25 ~ 28 60
Acceleration
4
4