Table of Contents
Advertisement
VII.B. Instrument Return (continued)
13. Replace the foam packaging material in
front of the platform.
14. Verify that the magnetic rod assembly,
plunger bar, and platform are securely
anchored by trying to move these pieces
by hand. If any of these are loose, repeat
the procedures above until they are secure.
15. Close the instrument door.
Repacking the Maxwell
1.
Place the instrument back into the plastic bag.
2.
Place the two foam packaging protectors on the sides of the instrument.
3.
Slide the instrument into the small inside shipping box. Ensure that the top of the instrument is facing
the top of the open box.
4.
Slide the small inside shipping box containing the instrument into the large outside shipping box.
5.
Repack the Maxwell
a.
Verify that the Hex Wrench is taped to the top of the instrument.
b.
Rewrap the Cartridge Preparation Rack and Magnetic Elution Tube Rack in bubble wrap.
c.
Place the Cartridge Preparation Rack and Magnetic Elution Tube Rack on top of the
instrument.
d.
Place the RS-232 Cable (in a reclosable bag) into the box.
e.
Place the Power Cable into the box.
6.
Affix the Certificate of Decontamination on the outside of the shipping box. Write the return
authorization number provided to you by Promega or your local Promega representative on the
outside of the shipping box. Seal the Box securely.
VII.C. Instrument Disposal
Contact your local Promega Representative for disposal of the instrument. Please follow your
institutional requirements to handle the disposal of accessories.
Promega Corporation · 2800 Woods Hollow Road · Madison, WI 53711-5399 USA · Toll Free in USA 800-356-9526 · Phone 608-274-4330 · Fax 608-277-2516 · www.promega.com
Part# TM274
Page 30
16 Instrument
®
16 Instrument accessories.
®
Printed in USA.
Revised 6/08
Advertisement
Table of Contents
