Table of Contents
Advertisement
III.D. Operational Mode Setup
Plugging the Instrument into the Power Outlet
1.
Once the magnetic rod assembly/plunger bar shipping anchors have been moved from their shipping
anchor positions, all inside packaging materials have been removed, and configuration
(if required) is complete, you can connect the instrument to a power outlet.
2.
Ensure that the power switch is in the off position. The power switch is located next to the power cord
connection on the back of the instrument.
3.
Connect the power cord into the back of the Maxwell
4.
Plug the power cord into a wall outlet. See Section I.A for power requirements.
5.
Close the door.
6.
Turn the machine on.
7.
Once turned on, the instrument will display the firmware version number and operational mode
setting, proceed through a self-check and home all axes.
8.
Connecting to the serial port on the back of the instrument is not required. Store the RS-232 Cable in a
location near the instrument.
Promega Corporation · 2800 Woods Hollow Road · Madison, WI 53711-5399 USA · Toll Free in USA 800-356-9526 · Phone 608-274-4330 · Fax 608-277-2516 · www.promega.com
Part# TM274
Page 16
16 Instrument.
®
Printed in USA.
Revised 6/08
Advertisement
Table of Contents
