Table of Contents
Advertisement
III.D. Operational Mode Setup (continued)
(i)
Setting the Maxwell
1. Make sure the instrument door is closed and turn on the Maxwell
homing itself during power up, the screen will display both the firmware version number and the
instrument's current operational mode setting.
2. Verify that the current operational mode displayed matches the
operational mode required by both the installed hardware and the
purification kit to be used (see Table 1).
3. If the operational mode displayed does not match the operational
mode required by the purification kit, you will need to change the
instrument setting (see (ii) below, "
Instrument Operational Mode"
(ii) Changing the Maxwell
1. Press the "Menu" button to get to the Menu screen.
2. Scroll down to move the cursor to "Setup". Press "Run/Stop" to
select "Setup".
3. Scroll up/down to move the cursor to the desired operational
mode. Press "Run/Stop" to select.
Refer to Table 1 for information on the operational mode required
!
for each Maxwell
4. Scroll down to move the cursor to the desired hardware mode.
If the instrument is configured with the Standard Elution
Volume hardware, select "SEV". If the instrument is configured
with the Low Elution Volume hardware, select "LEV".
Press "Run/Stop" to select.
Promega Corporation · 2800 Woods Hollow Road · Madison, WI 53711-5399 USA · Toll Free in USA 800-356-9526 · Phone 608-274-4330 · Fax 608-277-2516 · www.promega.com
Part# TM274
Page 18
16 Instrument Operational Mode
®
Changing the Maxwell
).
16 Instrument Operational Mode
®
16 Purification Kit.
®
16 Instrument. While the instrument is
®
Promega MAXWELL 16
Purification System
Version 4.0
LEV
16
®
Operational Mode Setting
SEV = Standard Elution Volume
LEV = Low Elution Volume
Rsch = Research
Fnsc = Forensic
====Menu====
1.
2.
3.
===Setup===
1.Research Mode
2.Forensic Mode
3.Cancel
==Hardware Setup==
1.SEV Hardware
2.LEV Hardware
Fnsc
Run
Demo
Setup
Printed in USA.
Revised 6/08
Advertisement
Table of Contents
