H) Switching On Receiver Power Supply; I) Switching On The Speed Controller - Reely ROAD Carbon Fighter Operating Instructions Manual

h) Switching on the Receiver Power Supply
If you didn't do so before, switch on the transmitter,
see chapter 8. d).
Put the on/off switch for the receiver power supply (see
circle in the figure on the right) in the „ON" position.
Now the two steering servos should move to their neu-
tral position.
If the front wheels are not aligned straight, you can
correct the trim for the steering at the transmitter. The
exact setting for straight driving can be performed
during a drive.

i) Switching on the Speed Controller

Observe chapters 8. a) to h). Place the vehicle on a suitable support as described in chapter 8. g) to
ensure the wheels can turn freely.
Do not reach into the drive. Do not hold the wheels! Risk of injury!
Leave the throttle/brake lever at the transmitter in its neutral position and do not move it.
Put the on/off switch for the speed controller (see circle
in the figure on the right) in the „ON" position. Move
the switch in the direction of the setup button for this.
The red LED at the speed controller should now flash
4 times, and the motor should emit 4 beeps. The oran-
ge LED also lights up.
If the red LED does not flash after switching on and the motor does not emit any sound signals, while only
the orange LED is lit, the correct neutral position could not be recognised. In this case, set the trimming of
your transmitter correctly or programme the full throttle and neutral positions of the speed controller; see
chapter 10. a).
The sounds are generated by a short start-up of the brushless motor. The sound signals may be very low,
depending on the motor. In this case, observe the LED on the speed controller.
Then check the drive and steering functions of the vehicle; see chapter 8. k).
42