Commissioning; A) Installing The Receiver Aerial Cable; B) Inserting Batteries/Rechargeable Batteries In The Transmitter; C) Taking The Transmitter Into Operation - Reely ROAD Electro Street 4WD RtR Operating Instructions Manual

9.

Commissioning

a) Installing the Receiver Aerial Cable

Now remove the car body. Remove the car body splints
and take off the body upwards.
Guide the aerial cable through the aerial tube (1) and plug
it into the respective holder (2) at the top of the vehicle.
For a wide range, the aerial needs to protrude from the
vehicle as vertically as possible.
Never shorten the aerial cable! Never coil the aerial cable!
This greatly reduces the range.
b) Inserting Batteries/Rechargeable Batteries into the Transmitter
Open the transmitter's battery compartment and insert either batteries or fully charged rechargeable batteries. Obser-
ve correct polarity (plus/+ and minus/-), see label on the battery compartment. Close the battery compartment again.
Observe the enclosed operating instructions for the remote control system.

c) Taking the Transmitter into Operation

Switch on the transmitter and put the trimming for steering and driving functions into the centre positions. If the trans-
mitter has a dual rate function, deactivate it or set it to unlimited steering deflection.
Observe the enclosed operating instructions for the remote control system.
d) Inserting the Drive Battery into the Vehicle
Attention!
The drive battery must not be connected to the speed controller yet. First switch on the transmitter, see
chapter 9. b) and c).
Important!
This vehicle is suitable only for use with a LiPo drive battery with 2 cells (nominal voltage of drive battery
7.4 V) or NiMH/NiCd drive battery with 6 cells (nominal voltage 7.2 V).
When using a drive battery with more cells, there is a danger of fire from overheating of the speed controller.
Apart from this, the vehicle's drive will be overloaded and damaged by this (e.g. differential). Loss of gua-
rantee/warranty!
42
1
2