Table of Contents
Advertisement
Technical Information
1
Technical Data
Design
Table 010-1: Casing Technical Data
3
Fault Repair
3.1
Vibrations during Spin Cycle
Cause:
The shipping struts are still in the appliance.
Remedy:
Remove the shipping struts.
Note:
To set up and connect the appliance, refer to the operating instructions.
Cause:
The floor is unstable.
Remedy:
Set up appliance on a sound floor that can support the appliance.
Note:
Floors are more stable in the corners of a room than in the middle of a
room.
Warning!
When installing the appliance on a stand on site, secure the appliance with
clamps to keep it from slipping off.
Cause:
The washer is not level.
Remedy:
Level the washer, adjust the feet and counter-lock.
4
Service
4.1
Lid Removal
1. Disconnect the machine from the power supply.
2. Remove the screw caps from the sides of the lid. See Figure 010-1.
3. Loosen the T20 screws a maximum of 5 turns. Do not unscrew the
screws completely.
4. Press in on the screws.
5. Lift the lid at the front and slide it back to release it from its retainers.
Take the lid off.
Frame construction
12
W 48xx
Advertisement
Table of Contents
