Table of Contents
Advertisement
W 48xx
Note:
Delete the fault memory before ending.
4.8
Removing the Control Electronic (EW) and Fascia Support Panel
1. Remove the appliance lid; refer to Section 010-4.1.
2. Remove the fascia panel by inserting a yellow Miele tool under one of the
edges and sliding it around the perimeter to release the panel.
3. Remove the two T20 screws securing the sides of the control electronic.
4. Pull up on the electronic to release it and disconnect the ribbon cable.
5. Remove the wiring diagram from the fascia support panel.
6. Remove the four T20 screws securing the front of the fascia support
panel.
7. Unsnap and remove the fascia support panel.
Figure 070-1: Control Electronic and Fascia Support Panel
79
Technical Information
Advertisement
Table of Contents
