Technical Data; Function; Door Lock (A2); Table 020-1: Door, Magnet, Lock - Special Tools - Miele W 4802 Technical Information

W 48xx
1

Technical Data

Special tools
Locking latch
View panel

Table 020-1: Door, Magnet, Lock - Special Tools

2

Function

2.1

Door Lock (A2)

2.1.1 Electromechanical Door Lock
When locking the door, the locking latch dips into the lock and is pulled into
the lock by the locking mechanism.
The power electronic (ELP) registers the locked state via a switch in the door
lock (A2).
During operation, with the door closed, the door lock is electromechanically
bolted; refer to Section 020-2.1.2.
As long as the door is not electromechanically bolted, the door can be
opened by simply pulling it.
Activating the emergency release cancels the electromechanical lock, and
the door can be opened.
Danger!
Opening the door by means of the emergency release may present danger
of injury by a rotating drum, danger of scalding suds and flooding.
Note:
Closing the door when the door lock is already locked causes damage to
the door lock.
If the door lock is locked with the door open, it has to be released manually;
refer to Section 020-4.1.
2.1.2 Safety Requirements
After pressing the Start pad, the electromechanical door lock is only activated
when the following safety requirements are met:

Drum speed less than 7 rpm, as registered by the tachogenerator,

Water level less than 3 ¼" wc, as registered by the imbalance sensor
(ADS),

Suds temperature less than 131°F (55°C), as registered by suds NTC
R30.
To run the appliance in service mode
with the front panel removed
To run the appliance in service mode
with the front panel removed
17
Technical Information