Table of Contents
Advertisement
W 48xx
2
To delete the fault memory: Press and hold Start button for longer than 4 seconds (all
saved faults are deleted).
3
To select and activate components: Press Start; after 1 second, activation follows
automatically. Pressing Start again switches the current component off and starts the
next one. If component testing is stopped and subsequently called up again, the
program resumes with the last component that was activated. The component test
switches off automatically 30 minutes after the last component is activated.
4
To select a sensor and start the check: Press Start.
Quit without saving:
If not in component test: Open the door.
If in component test: Use the Buzzer button to scroll to "Sensor test," go to
the second test (door contact) to unlock the door, then open the door.
Only interrupt the power supply as a last resort.
Note:
Delete the fault memory before ending.
4.6
Service Mode Overview, W 4802
Initial requirements:
1. Install and connect the appliance correctly.
2. End the current program as well as the demo mode.
3. Open the door.
Accessing:
Note:
Access has to be completed within 10 seconds.
1. Press Start and hold.
2. Close the door.
3. As soon as the "End" LED comes on, release Start.
4. Press Start 3 times; hold on the 3rd time until the "Start" LED flashes
slowly (1 flash per second).
Acknowledgement indicator:
"Start" LED flashes slowly (1 flash per second).
If accessing is not successful, the control reverts automatically to the normal
programming mode.
Options:
To select a service function: Press the Buzzer button.
To start a service function: Press Start.
Note:
The component test switches off automatically 30 minutes after the last
component is activated.
71
Technical Information
Advertisement
Table of Contents
