Table of Contents
Advertisement
Technical Information
EW = Soak
HW = Main wash
KB = Cottons/colors
PFL = Delicates
VW = Prewash
SPST = Rinse hold
OSCHL = No spin
Save and quit:
Open the door.
Note:
The indicated programming options are saved in the power electronic (ELP).
4.2
Activating/Deactivating Demo Mode (W 4800, W 4802)
Initial requirements:
1. Finish the current program.
2. Open the door.
Accessing:
Note:
Access has to be completed within 10 seconds.
1. Press and hold Start.
2. Close the door.
3. When the "Start" LED lights up steadily (after about 5 seconds), release
the Start button.
4. Press Start again immediately and hold until the "Start" LED goes out.
Acknowledgement indicator:
The "Start" LED flashes in a rhythm of 2 times short, 1-second pause.
If accessing is not successful, the control reverts automatically to the normal
programming mode.
Options:
The demo program runs through automatically.
One demo program cycle lasts approximately 40 seconds.
Note:
After a power interruption, the demo program starts again on its own.
Operating simulation/Interactive demo mode:
In the demo mode, the appliance can be operated without actually starting a
program.
Save and quit:
To deactivate the demo program, repeat the access procedure.
4.3
Programming Mode (W 4840, W 4842)
Initial requirements:
1. Install and connect the appliance correctly.
2. End the current program as well as the demo mode.
62
W 48xx
Advertisement
Table of Contents
