Procedure
1. Enter Global Configuration mode:
enable
configure terminal
2. Use the snmp-server host <host-ip> v1 <community-string> command to add
the trap receiver to the table.
3. You can use the show snmp-server host command to confirm the configuration change.
Adding an SNMPv2c trap receiver
Use this procedure to add an SNMPv2c trap receiver to the trap receiver table.
Procedure
1. Enter Global Configuration mode:
enable
configure terminal
2. Use the snmp-server host <host-ip> v2c <community-string> command to add
the trap receiver to the table.
3. You can use the show snmp-server host command to confirm the configuration change.
Adding an SNMPv3 trap receiver
Use this procedure to add an SNMPv3 trap receiver to the trap receiver table.
Procedure
1. Enter Global Configuration mode:
enable
configure terminal
2. Use the snmp-server host <host-ip> v3 <auth | auth-priv | no-auth>
<SNMPv3_username> command to add the trap receiver to the table.
3. You can use the show snmp-server host command to confirm the configuration change.
July 2015
Comments on this document? infodev@avaya.com
Adding an SNMPv2c trap receiver
Troubleshooting Avaya VSP 7000 Series
63