Enabling Ddi Logging; Viewing Ddi Logging Status - Avaya Virtual Services Platform 7000 Series Troubleshooting Manual

Troubleshooting SFP

Enabling DDI logging

Procedure
1. Enter Ethernet Interface Configuration mode:
enable
configure terminal
interface Ethernet <port>
2. At the command prompt, enter the following command:
ddi-logging enable [port <port>]
Note:
By default, logging is disabled for all ports.
Variable definitions
The following table describes the parameters for the ddi-logging command.
Variable
port <port>

Viewing DDI logging status

Procedure
1. Log on to ACLI to enter User EXEC mode.
2. At the command prompt, enter the following command:
show ddi-logging
Example
The following example shows sample output of the show ddi-logging command.
7024XLS>show ddi-logging
DDI Logging enabled on ports : 1
Troubleshooting Avaya VSP 7000 Series
46
Value
Specifies the port in one of the following formats: a
single port (3), a range of ports (3-4), or a series of
ports (3,5,6).
Comments on this document? infodev@avaya.com
July 2015