4/ Assembly And Installation - Kontron 11529 User Manual

4/ Assembly and installation

Prior to commissioning, the temperature of the unit must be adjusted to the room temperature.
Observance of the standards and regulations of the country of destination
Improper installation may result in death, serious injury or serious damage to property.
The device must be installed in machines or systems in compliance with all standards and
regulations applicable in the countries of destination and may only be installed by a trained
specialist who is familiar with the respective regulations.
Malfunctions due to improper earthing of the device.
The device must be properly grounded.
Compliance with the prescribed EMC limit values can only be guaranteed if the device is
properly grounded.
Damage to plugs or cables due to improper handling when plugging in and plugging out
Material damage to cables, plugs and other plant components can result.
Always hold the plug when plugging and unplugging a cable.
:
Observe correct installation position
The device is exclusively intended for operation when mounted on the top hat rail in book
form in accordance with the installation instructions in chapter 4.1. The prescribed minimum
distances to other devices mounted on the top hat rail must be observed. If the device is not
mounted according to the instructions, heat dissipation cannot be guaranteed and the
device will overheat. This in turn can result in a loss of performance or an unexpected
shutdown of the device.
www.kontron.com
Control Unit CUmini 5x-2x0x - Rev. 1.A
// 23