Table of Contents
Advertisement
Cutting Multiple Sets of the Same Cutting Data
Cut Only
You can repeatedly cut the preceding cutting job sent to the cutting machine for the specified number
of times while maintaining the cutting data's relative distance from the origin.
MEMO
• To send jobs from the printer driver, open the [Printing Preferences] window, and then select the [Back to Home]
check box.
• To send jobs from GreatCut-R, open the [Output to device] window, and then set [Origin] to [Don't set].
Procedure
1.
Load the material and measure its size.
P. 21 "Loading the Material"
2.
Press [ON/OFF LINE] to switch to offline mode.
3.
Press [CUT TEST].
4.
Press [▶] several times to display the screen shown below.
Redo Jobs in Memory
Select:
5.
Press [ENTER].
The current value is displayed on the screen.
Recut
Select:
6.
Press [▶] to select "Copy".
Copy
Select:
7.
Press [▲] or [▼] to select the number of repetitions.
8.
Press [ENTER].
Cutting starts for the specified number of times.
9.
When the cutting is finished, press [ON/OFF LINE] to go back to the original screen.
RELATED LINKS
・ P. 54 "Sending Cutting Jobs from GreatCut-R"
・ P. 109 "Setting Overlap Cutting Using the Printer Driver"
96
Other Cutting
OK:ENTER
# 1
OK:ENTER
# 1
OK:ENTER
Advertisement
Table of Contents
