Table of Contents
Advertisement
Loading the Material
11.
Check that the roll material is equally taut on the left and right.
Twisted material may indicate that it is not being fed in a straight manner. Adjust the position
of the material and reload it.
12.
Set the material feeding so the material length required for the cutting data is fed before cutting
starts.
P. 130 "Preventing Positioning Errors by Setting Material Feeding"
13.
For roll material 4 m (157.49 in.) or more in length, feed the loaded material, checking that there is
no misalignment or twisting.
(1)
Turn on the power.
When you turn on the power, the screen for measuring the material size appears.
Roll
Key
(2)
Press [▲] or [▼] to measure the material size.
(3)
Press [▼] to feed about 1 to 2 meters (39.37 to 78.74 in.) of the material.
MEMO
After the material size is measured, press a cursor key to display the screen for setting the output-
start location. To test the feeding of the material and check that it has been set up, only press [▼] on
this screen.
26
Basic Settings and Operations
Edge
Single
Key
Key
Advertisement
Table of Contents
