Roland Camm-1 GR2-640 User Manual page 3

Contents
Automatic Aligning System (AAS)................................................................................................58
Crop Mark Types .............................................................................................................58
Setting the Margins and the Distance between Crop Marks .................................................................61
Automatic Detection of Material Feed Direction .............................................................................62
Setting the AAS Detection Mode ..........................................................................................63
Setting Crop Marks in Cutting Data .............................................................................................64
Setting Crop Marks with the AAS Plug-in (Adobe Illustrator) .........................................................64
Setting Crop Marks with the AAS Plug-in (CorelDRAW) ................................................................66
Setting Crop Marks with the GreatCut-R Plug-in (Adobe Illustrator/CorelDRAW) .................................68
Setting Crop Marks with GreatCut-R......................................................................................69
Printing Cutting Data on Material ...............................................................................................71
Printing Cutting Data from GreatCut-R ..................................................................................71
Setting the Output-start Location (Printing and Cutting) ...................................................................73
Performing Cutting ................................................................................................................74
Sending Adobe Illustrator Cutting Jobs from the Printer Driver......................................................74
Sending CorelDRAW Cutting Jobs from the Printer Driver.............................................................77
Sending Cutting Jobs from GreatCut-R...................................................................................79
Other Cutting .......................................................................................................... 82
Section Cutting.....................................................................................................................83
Setting Up Section Cutting .................................................................................................83
Cutting Perforated Lines..........................................................................................................84
Setting Up Perforated Cutting Using the Printer Driver ...............................................................84
Setting Up Perforated Cutting with GreatCut-R ........................................................................86
Setting Up Perforated Cutting from the Operation Panel .............................................................89
Cutting Multiple Sets of the Same Cutting Data ..............................................................................90
Duplicating Cutting Data with the AAS Plug-in .........................................................................90
Duplicating Cutting Data with the GreatCut-R Plug-in ................................................................90
Duplicating Cutting Data with GreatCut-R ..............................................................................92
Cutting the Cutting Data Repetitively on Operation Panel............................................................94
Optimizing Quality and Efficiency ................................................................. 97
Using GreatCut-R ...................................................................................................... 98
Setting Up Cutting by Layer ......................................................................................................99
Configuring the Cutting Conditions Based on the Color of Cutting Lines ...........................................99
Manually Setting the Cutting Order..................................................................................... 101
Simulating the Cutting Order ............................................................................................ 102
Setting the Weed Border........................................................................................................ 104
Using the Material with Minimal Waste....................................................................................... 106
Aligning Cutting Data by Conditions (Nesting) ........................................................................ 106
Optimizing the Output Quality .....................................................................................108
Dealing with Material Thickness/Hardness (Softness)...................................................................... 109
Overlap Cutting ............................................................................................................ 109
Adjusting the Cutting-in Amount........................................................................................ 112
Cutting the Corners Longer to Make It Easy to Detach Cutting Data (Over Cut) ....................................... 113
Cutting Small Text and Complex Graphics Cleanly (Tangential) .......................................................... 114
Smoothly Cutting Arcs and Other Curves (Smoothing) ..................................................................... 115
Preventing and Correcting Misaligned Cutting .............................................................................. 116
Keeping Material in Place and Stabilizing Cutting Accuracy ........................................................ 116
Correcting Distance during Cutting Based on the Thickness of Material.......................................... 117
Cutting Efficiently ...................................................................................................119
Using Presets ..................................................................................................................... 120
Saving Cutting Conditions in Presets on the Operation Panel ...................................................... 120
Saving Presets Using the Printer Driver ................................................................................ 121
2