Roland Camm-1 GR2-640 User Manual page 96

・ P. 54 "Sending Cutting Jobs from GreatCut-R"
Printing and Cutting
Load in the device the same cutting data printed on multiple pieces of material, and then use the op-
eration panel to repetitively cut a preceding AAS job recorded in the machine.
MEMO
Turning the power off will disable the record of the preceding AAS job sent to the machine.
Procedure
1.
Load the material and measure its size.
P. 21 "Loading the Material"
2.
Press [ON/OFF LINE] to switch to offline mode.
3.
Press [CUT TEST].
4.
Press [▶] several times to display the screen shown below.
Repeat AAS Job
Select:
5.
Press [ENTER].
The screen shown below appears. Cutting starts after the crop marks are read.
AAS Detecting
RELATED LINKS
・ P. 54 "Sending Cutting Jobs from GreatCut-R"
・ P. 109 "Setting Overlap Cutting Using the Printer Driver"
OK:ENTER
OK:ENTER
Cutting Multiple Sets of the Same Cutting Data
95
Other Cutting