Cleaning The Machine; Cleaning The Parts That Come Into Contact With The Material - Roland Camm-1 GR2-640 User Manual

Cleaning the Machine

Clean this machine periodically to ensure use under optimal conditions.
Be sure to perform operations as specified by the instructions, and never touch
WARNING
any area not specified in the instructions.
Sudden movement of the machine may cause injury or burns.
Never use a solvent such as gasoline, alcohol, or thinner to perform cleaning.
WARNING
Doing so may cause a fire.
IMPORTANT
Disconnect the power cord before starting cleaning.
Do not use solvents, detergents with abrasive components, or strong cleansers. Using such cleaning products may
cause damage to the surface of the cutting machine or movable parts.

Cleaning the Parts that Come into Contact with the Material

Wipe off dirt and grime with a cloth moistened with water and then wrung out firmly.
Pinch roller
*1
Carriage rail
Paper sensors
Platen
*1
Grit roller
*1 When cleaning, move the cutting carriage away from where you are cleaning.
*2 Do not use a metal brush.
Hold the roller with your hand so that it does not turn, and wipe off grime and
material scraps from the rubber part of the pinch roller. Then, wipe clean with
a dry cloth.
Wipe away any dust and grime.
After wiping away dust and grime, wipe clean with a dry cloth.
After wiping away dust and grime, wipe clean with a dry cloth.
After raising all of the pinch rollers, turn the grit roller while using a brush
remove dust from the surface.
Cleaning and Replacing Consumable Parts
*2
to
135