Roland Camm-1 GR2-640 User Manual page 60

Set the size (length) and line width of the crop marks, as well as their margins from the object, within
the range below.
Length
Thickness
Margin
Segmental
Segmentation allows for correction of warpage that occurs when cutting long materials and scans the
material in sections when section cutting is used. This type of crop mark is best used for long printed
materials. Intermediate crop marks are added between four-point crop marks at distances specified in
X (feed direction) and Y (width), respectively, from the crop mark origin ( ).
Section1
Section1
X: feed direction
[Y] Width of material
Multiple
Based on the four-point crop mark settings, crop marks can be set by specifying the number of dupli-
cates and the main direction (X and Y directions). This operation sets one crop mark to the selected
objects at once, which is recommended for multiple cutting of complex objects.
Setting item
Section2 Section3
Section2 Section3
AAS plug-in setting range
50 to 600 mm (1.97 to 23.62 in.)
200 to 600 mm (7.88 to 23.62 in.)
Setting range
5 to 50 mm (0.2 to 1.96 in.)
1 to 2 mm (0.04 to 0.07 in.)
0 to 50 mm (0 to 1.96 in.)
Section4
Section4 Section5
200 to 600 mm (7.88 to 23.62 in.)
200 to 600 mm (7.88 to 23.62 in.)
Automatic Aligning System (AAS)
Recommended value
25 mm (0.98 in.)
1 mm (0.04 in.)
5 mm (0.2 in.)
Section5
X
Section6
X
GreatCut-R plug-in setting range
Basic Printing and Cutting
59