Technical Specifications; Status Leds - Honeywell Pro-Watch 7000 Install Manual

Technical Specifications

Caution: PW-7000 is manufactured for use in low-voltage, Class 2 power-
Table 3 PW-7000 Technical Specifications
Category
Primary Power
Reader Ports
Memory and Clock
Ports
Inputs
Cable requirements
Environmental
Mechanical
Note: Specifications subject to change without notice.
Caution: Locate the power source as close to this board as possible.
Note: POLARITY for 12 VDC power is important. Make sure the +12 VDC is connected to the
terminal labeled +12V and the return is connected to the terminal labeled GND.

Status LEDs

Power-up: All LED's OFF.
20 PW-7000 (PW7K1IC) Installation and Configuration Guide, Document 800-25673V1
limited circuits only.
Description
12 VDC ± 10%, 500 mA maximum (reader ports not included)
600 mA maximum for 12V readers (add 600 mA to primary
power current) 300 mA for 5V readers.
3Volts Lithium, type BR2330 or CR2330.
Backup
Port 0 - Host Communication:
Ethernet: 10-BaseT/100Base-TX
Port 1 - Serial I/O Device:
2-wire RS-485, 2,400 to 115,200 bps, asynchronous, half-
duplex, 1 start bit, 8 data bits, and 1 stop bit
Reader Interface:
Data Inputs: TTL compatible, F/2F or 2-wire RS-485. RS-485
Mode: 9,600 to 115,200 bps, asynchronous, half-duplex, 1
start bit, 8 data bits, and 1 stop bit. Maximum cable length:
2000 ft. (609.6 m)
8 unsupervised/supervised, standard EOL: 1k/1k ohm, 1%, ¼
watt
2 non-supervised, dedicated for cabinet tamper and power
fault monitoring.
Power:1 twisted pair, 18 AWG.
RS-485:
I/O Device Port: 1 twisted pair, shielded, 120 ohm impedance,
24 AWG, 4,000 ft. (1,219 m) max.
Reader Port: 1 twisted pair, shielded, 120 ohm impedance, 24
AWG, 2,000 ft. (610 m) max.
Alarm Input: 1 twisted pair, 30 ohms maximum
Ethernet: Cat 5.
Input: 1 twisted pair, 30 ohms maximum.
Temperature: 0 to 49°C, operating
-55 to +85°C, storage
Humidity: 0 to 85% RHNC
Dimensions: 5.5 in. (137.7mm) W x 9 in. (228.6.4mm) L x.75
in. (19.05mm) H
Weight: 7.1 oz. (201 gm) nominal
Connect power with minimum of 18AWG wires.