Reader Wiring; Input Wiring - Honeywell Pro-Watch 7000 Install Manual

Reader Wiring

The following Honeywell reader module numbers have been approved by UL for
use with the PW7K1R2: OM40BHONA, OM55BHONA, OP10HONE, OP30HONE,
OP40HONE, OP90HONE, OT30HONA, OT31HONA, OT35HONA, and OT36HONA.
Each reader port supports a reader with TTL interface. Power to the reader is
selectable as 5VDC or 12VDC (pass-through). This selection is done by setting the
jumpers J2 for reader 0 and J3 for reader 1. Set jumper at position "5" for 5VDC or
"12" for pass-through 12VDC. The factory defaults set J2 and J3 to "5".
For wiring to a reader port:
Table 5: Settings for Wiring to a Reader Port
Terminal
1
2
3
4
5
6
The LED control terminal in each reader port can be configured via host software
to support one-wire single or bi-colored reader LED. An example of the most com-
mon configuration is shown below. If Beeper Control is not used, its terminal can
be programmed to be the second wire for the two-wire bi-colored reader LED.
Table 6: Settings for Configuring an LED Control Terminal
LED Output->
Single Color LED
Bi-Color LED
To fully utilize each reader port, a 6-conductor cable (18AWG) is required. Reader
port configuration is set via host software.

Input Wiring

Inputs 0 to 7 may be configured to use normally open or normally closed contacts
and non-supervised or supervised (with standard ±1% tolerance 1K ohm). Four of
these inputs have default functional definitions, but all eight can be configured to
monitor general-purpose sensors.
PW-7000 (PW7K1IC) Installation and Configuration Guide, Document 800-25673V1
Typical Wire Color Wiegand Reader
Red Power (5 or 12 Vdc)
Brown LED control
Yellow Beeper Control
White Data 1 Signal
Green Data 0 Signal
Black Common
High
LED On
Green LED On
Clock/Data Reader
Power (5 or 12 Vdc)
LED control
Beeper Control
Clock Signal
Data Signal
Common
Tri-Stated
LED Off
Both LEDs Off
Low
LED Off
Red LED On
39