Bulk Erase Configuration Memory
The bulk erase function can be used for the following purpose:
•
•
•
Note: If clearing the memory does not correct the initializing problem, contact technical
support.
Bulk Erase
Note: Do not remove power during steps 1-8.
Step 1.
Step 2.
Step 3.
Step 4.
Step 5.
Step 6.
Step 7.
Step 8.
PW-7000 (PW7K1IC) Installation and Configuration Guide, Document 800-25673V1
Erase all configuration and cardholder database (sanitize boards, less third
party applications)
Update the OEM default parameters after OEM code is changed.
To recover from the database corruption and to avoid PW7000 board to reboot
continuously.
Set S1 DIP switches to 1 & 2 "ON" and, 3 & 4 "OFF".
Apply power to the PW7K1IC board. LED 1 ON for about 15 seconds while
PW7K1IC boots up.
After the PW7K1IC boots up, watch for LEDs 1& 2 and 3 & 4 to alternately
flash at a 0.5 second rate.
Within 10 seconds after the above patterns starts, change switches 1 or
2 to "OFF". If these switches are not changed, then PW7K1IC board will
power up using the OEM default communication parameters.
LED 2 will flash indicating that the configuration memory is being
erased.
Full memory erase will take up to 60 seconds, usually a lot less.
Once complete. only LED's 1 & 4 will flash for 3 seconds.
The PW7K1IC board will complete its initialization in 2 seconds after
LEDs 1 & 4 stop flashing.
19