Cabinet Tamper And Power Failure Input Wiring - Honeywell Pro-Watch 7000 Install Manual
Intelligent controller and system
Hide thumbs
Also See for Pro-Watch 7000:
- Install manual (28 pages) ,
- Security manual (20 pages) ,
- Install manual (22 pages)
Table of Contents
Advertisement
Figure 3: PW-7000 Port Wiring
Cabinet Tamper and Power Failure Input Wiring
Figure 4: PW-7000 TMP and FLT Terminals
Inputs TMP and FLT are used for monitoring cabinet tamper and power failure with
normally closed contacts. These two inputs are for contact closure monitoring
only; do not use end-of-line (EOL) resistor(s). If these inputs are not used, install a
short piece of wire at the input to indicate a safe condition.
24
PW-7000 (PW7K1IC) Installation and Configuration Guide, Document 800-25673V1
Hide quick links:
Advertisement
Table of Contents
