Regal 3300 Owner's Manual page 100

CHAPTER 3
Fwd Bilge Pump
This switch controls the bilge pump manual operation. The bilge pump
is used to remove any accumulated bilge water. It send the water through
a hose and a hull fitting to the outside hull. Even with the switch in the
off position the bilge pump will automatically activate through a float
switch located near the pump itself. This feature is especially useful
when the vessel is moored and vacant. When excess water causes the
float switch to rise the pump activates in the automatic position and a
red icon lights up on the switch bottom. The operator should monitor
this icon periodically while operating the vessel. If the light activates,
stop the vessel and investigate the problem. Check the bilge pump
before each outing and remove any foreign objects caught in the float
switch or bilge pump grating. Never run the bilge pump in a dry mode
since it may shorten the pump life. The bilge pump is energized even
with the battery switch turned to the "off " position.
Aft Bilge Pump
This switch controls the bilge pump normally located in the aft cockpit
under the front of the engine. The switch operates the same as the
forward bilge pump.
Hatch
This cockpit switch controls the electric hatch operation. Should the
batteries go dead, plug in a 3-prong grounded 14-gauge extension cord
into the battery charger plug. After a few minutes, you should be able
to raise the hatch with the extension cord still plugged into the plug.
Make sure all body parts are clear of the hatch when it is traveling up
or down.
https://www.boat-manuals.com/
3-24