Chapter 11 Compliance With Global Standards; Compliance With Global Standards; Compliance With China Compulsory Certification (Ccc) - Mitsubishi Electric -MR-CV User Manual

11

COMPLIANCE WITH GLOBAL STANDARDS

This chapter describes the converter unit and drive units as servo amplifiers.
11.1
Compliance with global standards
Refer to the following manual for information about compliance with global standards.
MR-CV_ Instructions and Cautions for Safe Use of AC Servos (IB(NA)-0300228)
11.2
Compliance with China Compulsory Certification
(CCC)
Introduction
Some products are required to comply with China Compulsory Certification (hereinafter referred to as CCC) if exported,
distributed, or sold to China. An outline of CCC is explained in this section. Mitsubishi Electric servo products are not subject
to CCC.
CCC mark
Outline of CCC
CCC is a system for product certification that has been in effect in China since August 2003, the purpose of which is to protect
consumers and ensure safety domestically in China. The certification system currently has five types of certification: safety,
electromagnetic compatibility (EMC), safety + EMC, fire-fighting equipment, and wireless LAN. Products subject to the
certification are allowed to be exported, distributed, or sold to China only if they are certified by this system.
Products that have received certification proving compliance with the relevant technical standards (or products declared by
the manufacturer as being compliant) must carry the specified mark (CCC mark). Many of the technical standards to be
applied are GB standards (Chinese national standards), which comply with global standards such as those set forth by the
IEC (International Electrotechnical Commission) and CISPR (International Special Committee on Radio Interference).
Judgment
20 product groups divided into 158 categories are specified as the subject products (announcement No. 45, 2014). The
following table shows whether the servo products are required to comply with CCC.
Product
AC servo amplifier
*1
AC servo motor
*2
Options
*1 Small capacity motors with a capacity of 750 W or lower are included in the catalog of products subject to CCC, but the requirements do
not apply to our products for the following reasons:
Explosion proof motors and controlled motors (servo motors, stepping motors, etc.) are excluded from the subject small capacity motors.
*2 Mitsubishi Electric option cables use the wires that is not classified into the cable category in the catalog.
Judgment
Not subject
Not subject
Not subject
11 COMPLIANCE WITH GLOBAL STANDARDS
11.1 Compliance with global standards
11
111