Magnetic contactor control connector (CN23)
Signal (device)
name
Magnetic contactor
drive output
5 SIGNALS AND WIRING
50
5.4 Signal (device) explanation
Symbol
Connector
Function and application
pin No.
MC1
CN23-1
Connect to the coil of the magnetic contactor and the power supply for magnetic
contactor control.
MC2
CN23-3
When the converter unit receives a start command from the drive unit, a short circuit
occurs between MC1 (CN23-1 pin) and MC2 (CN23-3 pin).
If the magnetic contactor control connector (CN23) is not used for control, set the rotary
switch for converter setting (SW1) of the converter unit to "1". (Page 28 Converter
unit switch settings and operation panel)
I/O signal
interface
type