Table of Contents
Advertisement
6.2
MR Configurator2
Engineering tool
MR Configurator2 (SW1DNC-MRC2-_) can be used with this drive unit.
For the engineering tool specifications and system configuration, refer to the installation guide of the engineering tool.
Precautions for using USB communication function and Ethernet
communication function
Note the following to prevent an electric shock or malfunction of the drive unit.
Connecting the power of a personal computer
Connect the power of a personal computer with the following procedure.
■When using a personal computer with an AC power supply
• When using a personal computer with a three-core power plug or a power plug with a grounding wire, use a three-pin
socket or ground the grounding wire.
• When your personal computer has a two-core power plug and has no grounding wire, connect the personal computer to the
drive unit with the following procedure.
1.
Disconnect the power plug of the personal computer from the AC power socket.
2.
Check that the power plug has been disconnected and connect the computer to the drive unit.
3.
Connect the power plug of the personal computer to the AC power socket.
• When using a personal computer with battery
The computer can be used as it is.
■Connection with other devices using drive unit communication function
When the drive unit is charged with electricity due to connection with a personal computer and the charged drive unit is
connected with other devices, the drive unit or the connected devices may malfunction. Connect the drive unit and other
devices with the following procedure.
1.
Shut off the power of the device to be connected with the drive unit.
2.
Shut off the power of the drive unit that was connected with the personal computer, and check that the charge light is off.
3.
Connect the device with the drive unit.
4.
Turn on the power of the drive unit and the connected device.
6 OPTIONS AND PERIPHERAL EQUIPMENT
120
6.2 MR Configurator2
Advertisement
Table of Contents
