Setpoint Entry Methods - GE Multilin 350 Series Instruction Manual

SETPOINTS MAIN MENU

6.1.1 Setpoint entry methods

6–2
Courtesy of NationalSwitchgear.com
SETPOINTS
S1 RELAY SETUP
S2 SYSTEM SETUP
S3 PROTECTION
▼
S4 CONTROLS
S5 INPUTS/OUTPUTS
898784.cdr
Before placing the relay into "IN SERVICE" mode, setpoints defining system characteristics,
inputs, relay outputs, and protection settings must be entered using one of the following
methods:
• Front panel, using the keypad and the display.
• Front USB port, or rear RS485, Ethernet 100 FX, Ethernet 10/100 BaseT (optional) port,
and a computer running the EnerVista SR3 Setup software supplied with the relay.
• Rear serial RS485, and a SCADA system running user-written software.
S1 RELAY SETUP
CLOCK
ACCESS PASSWORDS
COMMUNICATIONS
▼
EVENT RECORDER
TRANSIENT RECDR
FRONT PANEL
INSTALLATION
S2 SYSTEM SETUP
CURRENT SENSING
POWER SYSTEM
▼
BREAKER
USER CURVE
FLEXCURVE A
FLEXCURVE B
S3 PROTECTION
SETPOINT GROUP 1
SETPOINT GROUP 2
S4 CONTROLS
CHANGE SEPNT GROUP
VIRTUAL INPUTS
LOGIC ELEMENTS
▼
BREAKER CONTROL
COLD LOAD PICKUP
BREAKER FAIL
AUTORECLOSE
S5 INPUTS/OUTPUTS
CONTACT INPUTS
OUTPUT RELAYS
VIRTUAL INPUTS
350 FEEDER PROTECTION SYSTEM – INSTRUCTION MANUAL
CHAPTER 6: SETPOINTS
S3 SETPOINT GROUP 1
PHASE TOC
PHASE IOC1
PHASE IOC2
▼
[SENS] GROUND TOC
[SENS] GROUND IOC1
[SENS] GROUND IOC2
NEUTRAL TOC
NEUTRAL IOC1
NEUTRAL IOC2
THERMAL MODEL
S3 SETPOINT GROUP 2
PHASE TOC
PHASE IOC1
PHASE IOC2
▼
[SENS] GROUND TOC
[SENS] GROUND IOC1
[SENS] GROUND IOC2
NEUTRAL TOC
NEUTRAL IOC1
NEUTRAL IOC2
THERMAL MODEL