Tandem T:Slim X2 User Manual page 234

Chapter 25 – Ending Your CGM Sensor Session
Method 1
The safety lock that you removed from
the applicator (see Chapter 21.4) can be
used as a tool to remove the transmitter.
1. Grasp the end of the adhesive
patch. Peel adhesive patch
up and away from your body
to remove sensor pod and
transmitter.
2. Put sensor pod on flat surface.
3. Place the sensor pod on a
flat surface.
4. Hold the rounded edge of the
safety lock.
5. Make sure the jagged edge of the
safety lock is facing down, with
the arrow pointing up.
6. Push the safety lock down until it
will go no further. The transmitter
will "pop" out of the sensor pod.
234
Safety Lock
Transmitter with Safety
Lock snapped in
Method 2
If you did not save the safety lock
when you inserted the sensor, you can
use your fingers to spread out the tabs
at the back of the sensor pod.
1. Grasp the end of the adhesive
patch. Peel adhesive patch
up and away from your body
to remove sensor pod and
transmitter.
2. Put sensor pod on flat surface.
3. Grasp sensor pods wide end with
two fingers and place fingers in
sides' open slots.
4. Pull tabs away from transmitter.
Customer Technical Support: (877) 801-6901