Satel TR49 Integration Manual page 42

The table below shows the analogy of settings between Pacific Crest and SATELLINE radio
modems.
Pacific Crest setting
Identification: Owner
Identification: Channel Bandwidth
Identification: RF Power
Radio Link: Channel Selection Type
(Manual)
Radio Link: Current Channel
Radio Link: Link Rate
Radio Link:Modulation Mode
Radio Link:Scrambling
Radio Link:Transmit Retries
Radio Link:TX ACK Timeout
Radio Link:Csma Monitoring
Radio Link: AutoBase/AutoRover
Radio Link:Digisquelch
Radio Link:Forward Error Correction
Radio Link:Local Address (0 by default)
Radio Link:Remote Address (255 by default)
Serial Interface:Protocol Mode
Serial Interface:BREAK to Command
Serial Interface:Modem Enable: Yes
Serial Interface:Soft Break Enable
Serial Interface:EOT value (in 0.01s units)
Serial Interface:Digipeater Delay
Serial Interface:Local Node Repeater
Frequency Table
Data Security Code (must be 0=not used)
Potential conflicts:
FEC setting applies only to the SATELLINE-3AS mode, the other radio compatibility modes
have their own FEC bindings (although some previous or special firmware versions differ in
the way FEC setting is handled - in case of doubt please contact technical support)
Error check and Full CRC16 check must be OFF in SATEL/SATELLINE modem
SATELLINE RX/TX addressing does not use ARQ scheme like Pacific Crest radios.
Corresponding SATELLINE setting
not implemented
Channel spacing
TX power
Radio frequency
Radio frequency
Radio compatibility mode and channel
spacing determine the link rate
Radio compatibility
ON by default
not implemented
not implemented
Priority (RX=ON, TX=OFF) Default: TX
not implemented
Signal threshold
ON by default
Note: SATELLINE-EASy FEC must be OFF!
Primary RX address (RX1) (OFF by default)
Primary TX address (TX1) (OFF by default)
Radio compatibility
not implemented
not applicable
not implemented
Pause length (in serial port byte intervals)
not implemented
not implemented
Radio frequency
not implemented
41
SATEL-TR49
Integration Guide, V 1.7