Assembly Instructions - First Degree Fitness E850 User Manual

Assembly Instructions

STEP 1
Main Frame Assembly Instructions
REQUIRED
4 x M8 x 15mm Blots [15]
1
4 x M8 Spring Washers [21]
2
3 x Foot Levelers[7]
12
CAUTION
8
The Control Arm is heavy
and may swing freely during
this stage of assembly.
The Adjuster Knob is
pre-tightened from the
factory in the optimal
position for assembly in
relation to the Control
Arm. Do not loosen the
Adjuster Knob until the
Telescoping Tube has been
safely secured to the
underside of the Control
Arm.
STEP 2
Crank Arm Assembly Instructions
REQUIRED
Right Pedal [6]
1
2
CAUTION
Extreme over-tightening
could damage the aluminum
threads on the Crank Arm.
a)
Attach Telescoping Tube to the underside of the
control arm using 4xM8x15mm Bolts[15] and 4x M8
Spring Washers[21].
b)
Thread the 3xFoot levelers[7] into underside of base.
Adjust as required.
M8x15mm Bolts
M8 Spring Washers
Adjuster Knob
a) Secure Right Pedal [6] onto Crank Arm. The Pedal threads
have a blue coating which will feel very tight when threaded
onto the crank arm. This is a type of thread locker, and
once in contact with the crank arm threads will activate in
approximately 15minutes.
Right Pedal
Note: Allow 15 minutes for the thread
locker to activate before first time use.
Check pedal tightness periodically
thereafter with a 15mm wrench.
9
Foot Leveler