Assembly Instructions - Fr-E316 - First Degree Fitness FR-316 User Manual

Assembly Instructions - VX-2
STEP 1
Attaching Upper/Lower Frame—VX-2
REQUIRED
Upper Mainframe [1]
1
Lower Frame [3]
2
M10x65mm Bolt [13]
2 x M10x140 Bolts [15]
12
M10 Washer [20]
2 x M10 Curved Washers [21]
CAUTION
The Curved Washers can
damage paint if not lying
flush against oval tube when
tightened. Use care when
securing.
CAUTION
Align the Curved Washer with
curvature of frame for a flush
fit and to avoid scratching.
WARNING
Do not attempt to stand
rower until Footplate/Seat
Rail assembly is attached.
See following page for
details.
a) Open box and remove contents. Lie Upper Frame[1] on
it's back as shown here. In the bolt pack, locate
2 x M10x140mm Bolts[15] and M10 Curved Washers[21]
along with M10x65mm Bolt[13] and M10 Washer[20].
Connect the Lower Frame[3] to Upper using M10x140mm
Bolts first and do not tighten before installing the third
M10x65mm Bolt as shown lower right
b) 2 x M10x140mm Bolts[15] and 2 x M10 Curved Washers
[21]. Do not tighten.
CAUTION
c) M10x65mm Bolt[13] and M10 Washer[20] Tighten all
three bolts.
15
Lower Frame
Upper Frame
M10x140mm Bolt
M10 Curved Washer
M10 Washer
M10x65mm Bolt
.