Installation Procedure - Ricoh TH-C1 Technical Bulletin

FAX OPTION TYPE 3232

INSTALLATION PROCEDURE

For Machine Code: B156/B220 Copiers
WARNING
1. Never install telephone wiring during a lightning storm.
2. Never install telephone jacks in wet locations unless the jack is
specifically designed for wet locations.
3. Never touch uninsulated telephone wires or terminals unless the
telephone line has been disconnected at the network interface.
4. Use caution when installing or modifying telephone lines.
5. Avoid using a telephone (other than a cordless type) during an
electrical storm. There may be remote risk of electric shock from
lightning.
6. Do not use a telephone to report a gas leak in the vicinity of the leak.
CAUTION
1. Before installing the fax unit, switch off the main switch, and
disconnect the power cord.
2. The fax unit contains a lithium battery. The danger of explosion exists if
a battery of this type is incorrectly replaced. Replace only with the same
or an equivalent type recommended by the manufacturer. Discard
batteries in accordance with the manufacture's instructions.
NOTE FOR AUSTRALIA
Unit must be connected to Telecommunication Network through a line cord
which meets the requirements of ACA Technical Standard TS008.
NOTE: THE FAX UNIT MUST BE INSTALLED BY A CUSTOMER SERVICE
REPRESENTATIVE WHO HAS COMPLETED BASE COPIER AND FAX
UNIT TRAINING.
(Machine Code: B750)
4/19
B7508512A
B7508512A