Description Of The Front Panel - Culligan MP97 Manual

DESCRIPTION OF THE FRONT PANEL

In addition to the display there are 4 keys and 4 LEDs on the front panel :
1. Key [ CAL ] 

2. Key [ + ]
displayed in setting and/or calibration.

3. Key [ - ]
variable displayed in setting and/or calibration.
4. Key [ NEXT ] 
the changes to the variable displayed in setting and/or calibration.
5. Led [ K1 ]
6. Led [ K2 ]
7. Led [ L1 ]
8. Led [ L2 ]
PROGRAMMING WITH FRONT PANEL KEYBOARD
The procedure for programming the 16 parameters which can be modified from the front keyboard is as follows :
1. Press the [ CAL ] key
2. << CAL >> appears on the display
3. Press the [ NEXT ] key
4. <<P01>> appears indicating that it is possible to modify the first parameter.
5. Press the [ NEXT ] or [ CAL ] keys.
6. Value of parameter P01 appears, flashing.
7. Press [ + ] to increase value of P01.
8. Press [ - ] to decrease value of P01 (exits from programming and returns to measurement).
9. Press [ CAL ] to confirm new value
10. Press [ NEXT ] to retain old value in memory
11. P02, the following value, appears on display
12. Proceed as for steps 5 to 10.
NOTES:
1) When programming, it is possible to choose the parameter to be modified directly by pressing keys [ + ]
and [ - ] (e.g. if you are in <<P01>> , by pressing [ + ] six times you can pass directly to <<P07>> .
2) By choosing a parameter lower than <<P01>> or higher than the last (16), the µP 97 returns to normal
operation.
3) If no keys are pressed for ten seconds, the µP 97 returns automatically to normal operation.
4) There are other six parameters after the 16
possible to order the µP 97 with keyboard access to all parameters.
M003-23 - Rev. 03 - 05/2009
Permits entry to "PROGRAMMING" and "CALIBRATION"
Displays "GAIN" value (amplification factor) if in normal display; increases the variable
Displays "OFFSET" value (drift with respect to zero) if in normal operation; decreases the
Displays value of main measurement without offset/gain if in normal operation; eliminates

Status of relay 1 , on = relay ON = contact closed.

Status of relay 2 , on = relay ON = contact closed.

Reserved.

Reserved .
th
; these refer to programming the measurement range. It is
Microprocessore µP97
8