Led Board; Removing The Led Board; Installing The Led Board - Dell Precision 3560 Service Manual

LED board

Removing the LED board

Prerequisites
1. Follow the procedure in
2. Remove the SIM card.
3. Remove the microSD
4. Remove the base cover.
5. Remove the WLAN card.
6. Remove the WWAN card.
7. Remove the battery.
8. Remove the assembly inner
About this task
The following image indicates the location of the LED board and provides a visual representation of the removal procedure.
Steps
1. Open the latch and disconnect the smartcard reader cable from the connector on the USH-daughter board.
2. Remove the smartcard reader cable away from the USH-daughter board.
3. Disconnect the LED-board cable from the connector on the system board.
4. Remove the single screw (M2x3) that secures the LED board to the palm-rest assembly.
5. Lift the LED board and cable away from the palm-rest assembly.

Installing the LED board

Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
Before working inside your
card.
frame.
computer.
Removing and installing components 43