Installing The Base Cover - Dell Precision 3560 Service Manual

Hide thumbs Also See for Precision 3560:

Owner's manual (71 pages)

Setup and specifications (25 pages)

Setup and features information (8 pages)

Table Of Contents

100

101

102

103

104

105

106

107

108

109

110

111

112

113

Table of Contents

Steps

1. Loosen the eight captive screws that secure the base cover to the palm-rest assembly and keyboard assembly.

2. Using a plastic scribe, pry the base cover from the U-shaped indents at the top edge of the base cover to remove the base

cover from the palm-rest assembly and keyboard assembly.

3. Grasp the left side and the right side of the base cover and remove the base cover from the palm-rest assembly and

keyboard assembly.

NOTE:

Disconnecting the battery cable, removing the battery, or draining the flea power clears the CMOS and resets

the BIOS settings on your computer.

NOTE:

After your computer is reassembled and powered on, it prompts for the Real Time Clock (RTC) reset. When

the RTC reset cycle occurs, the computer restarts several times and then an error message is displayed– "Time of

day not set". Enter the BIOS when this error appears and set the date and time on your computer to resume normal

functionality.

4. Disconnect the battery cable from the system board.

5. Turn your computer over and press the power button for 15 seconds to drain the flea power.