Xerox Phaser 3052 Service Manual page 93

8. Remove the following (Figure 5):
Make note of the order that the Feed and Registration Drive Gears are remove in so they
can be re-installed correctly.
a. Feed and Registration Drive Gears, there is a Snap Ring on one gear.
b. Feed and Registration Clutch Bushings (2 Snap Rings).
c. Shaft Bushings (2), release the latches.
Feed & Registration Drive Gears
Clutch Bushings
Figure 5 Drive Gears and Bushings
9. On the Bottom of the printer, remove the Feed and Registration Sensor PWB Cover
ure 6).
a. Remove the screw (1).
b. Release the Latch and remove the cover.
Xerox® Phaser® 3052/3260 Service Manual
Snap Ring
10. Removing the Feed Sensor Actuator, release the actuator from the latch
Note the location of the Spring in the frame cutout for reinstallation.
Shaft Bushings
Feed Sensor Actuator
(Fig-
Latch
June 2014
4-41
Latch
Screw
Figure 6 Feed and Reg Sensors PWB Cover (Bottom View)
Figure 7 Feed Sensor Actuator (Bottom View)
(Figure 7):
Spring
Repairs
REP 1.26