Diagnostic (Edc) Mode - Xerox Phaser 3052 Service Manual

Diagnostic (EDC) Mode

Enter Diagnostic (EDC) Mode, using the steps outlined below. Refer to Section 6 General Pro-
cedures GP1, Diagnostics Entry and Exit, for detailed instructions.
1. Connect to the printer with a USB cable.
2. When the printer is in Ready mode, open the EDC ReadData application and select [Run}
in the Compressed Folders dialog box.
3. Select [Update LCD] in the EDC dialog box.
4. From the EDC window, select the <Menu> button.
NOTE: Allow 1 second for the printer to process the command before making the next
menu selection.
5. Once in EDC Mode, use the arrows to select the following sub-menus:
• NVM Read/Write
• NVM Initialize
• Test Routines
Select the <Enter> button to confirm menu selections and run diagnostics tests.
Select the <Upper Level> button to stop tests.
Select the <Exit> button to exit EDC mode.
Table 1 EDC Mode Menu
Level 1 Level 2
NVM Read/ Write 105 Charger
106 Development
107 Transfer
109 Fuser
110 LSU
NVM Initialize [Yes/No]
Xerox® Phaser® 3052/3260 Service Manual
Level 3 Level 4
MHV DC K [50-900]
Deve DC K [50-900]
[THV] K [50-900]
[THV] K_Dup [50-900]
Ready Temp [-10 - 10]
Print Temp [-10 - 10]
LD Power K [50-900]
Table 1 EDC Mode Menu
Level 1 Level 2
Test Routines 100 Motor
101 Clutch
102 Sensor
105 Charger
106 Development
107 Transfer
109 Fuser
110 LSU
June 2014
6-15
Level 3 Level 4
Main BLDC Status [Off]
Main BLDC Rdy Status:
[Low]
Tray 1 Pickup Status:
[Off]
Registration Status:
[Off]
Out Bin Full Status:
[Low]
Tray 1 Empty Status:
[Low]
Feed Sens Status: [Low]
Regi Sens Status: [Low]
Exit Sens Status: [Low]
K MHV Bias Status:
[Off]
K Dev Bias Status:
[Off]
K THV Bias Status:
[Off]
K THV - Bias Status:
[Off]
K [THV] Bias R Status: [0]
Temp A Status: [0]
LSU Mot1 Rdy Status:
[Low]
LSU Mot1 Run Status:
[Off]
LD Power4 Status:
[Off]
LSU HSync4 [Low]
General Procedures and Information
Diagnostic (EDC) Mode