Xerox Phaser 3052 Service Manual page 89

7. Remove the following (Figure 5):
a. Drive Gears (2).
b. Feed Clutch Bushing, remove the Snap Ring.
c. Feed Shaft Bushings (2), release the latch and rotate the bushing.
d. Feed Assembly screw (1).
Clutch Bushing
Figure 5 Feeder Drives
8. Remove the Feed Assembly bottom screws (2)
Xerox® Phaser® 3052/3260 Service Manual
Drive Gears
Screws
Feed Shaft Bushings
(Figure 6).
Figure 6 Feeder Assembly Bottom Screws (Bottom View)
The Brackets holding the Registration Pinch Rolls and Guide are Spring Loaded. Maintain light
pressure on the Brackets when removing them to avoid damaging parts or personal injury.
9. Remove the Registration Pinch Rolls and Paper Guide Brackets (2 screws)
Figure 7 Registration Pinch Rolls and Paper Guide Brackets
June 2014
4-37
Screws
CAUTION
Screws
REP 1.25
(Figure 7):
Repairs