Mode 1 - Digital Speed Control Mode - RHINO RMCS –2303 Operating Manual

Mode 1 - Digital Speed Control Mode

•
In this mode the drive works in speed mode. It tries to reach and maintain the speed as per set
parameter.
•
The speed can vary depending upon load and gains set.
•
Make sure that the set speed is always less than the motor can actually reach, otherwise the drive can
give uncertain result. For example if the maximum speed motor can reach at given voltage is 18000
always set speed less than 18000 RPM.
Hardware Connection:
Digital Control Mode in Software:
To run your motor on digital speed control mode select this mode from operation mode.
a).
https://www.robokits.co.in/
18 | P a g e