RHINO RMCS –2303 Operating Manual page 15

RESET PARAMETERS
To reset the drive to default configuration click 'Reset Parameters' button. This will set all parameters to default
values. When button is clicked software will ask for confirmation.
Click on "Yes" to reset the drive. After Clicking on 'Yes' if reset is successful confirmation message will be
shown. Power off and Power on the drive to load default parameters. If any physical jumpers are preset at
this point the slave id of the drive will be according to that otherwise slave id will be 11.
https://www.robokits.co.in/
15 | P a g e