Parameters - RHINO RMCS –2303 Operating Manual

Parameters

READ PARAMETERS
"Read Parameters" is used to read current parameters of drive.
SET A PARAMETER
•
Pressing 'Enter' on text box will change the parameter in drive but it will not be saved permanently. 'Write
Parameters' button must be clicked to save all parameters permanently.
•
Set Position Proportional gain, Velocity Feed Forward gain and Position Integral Gain as per requirement.
These can be used to remove vibrations and making movement of motor accurate.
•
Set Modbus slave address and lines per rotation. Lines Per Rotation is very important because it does have
effect on indication of speed feedback.
•
If slave address is changed the software will automatically change the slave id of currently connected
device.
•
Set Speed and Acceleration as per the requirement of application.
WRITE PARAMETERS
Once all the parameters are entered and tested, click on
These parameters will be changed permanently. Notification will be shown as below when all parameters
are written successfully.
"Write
https://www.robokits.co.in/
Parameters" to save all parameters in drive.
14 | P a g e